Search papers, labs, and topics across Lattice.
This study evaluates various manufacturing methods for complex soft pneumatic actuators, focusing on their geometric fidelity, compliance, structural integrity, and airtightness. Through process screening and improvement, the researchers identified specific limitations and defects associated with each method, concluding that fused deposition modeling (FDM) offers the most flexibility for optimization. Notably, the findings reveal that actuator airtightness is influenced by both wall thickness and extrusion-path design, providing a framework for aligning actuator architecture with manufacturing capabilities.
Fused deposition modeling emerges as the most adaptable method for creating airtight soft pneumatic actuators, with defects that can be systematically minimized through optimization.
Manufacturing complex soft pneumatic actuators remains challenging because geometric fidelity, compliance, structural integrity, and airtightness must be achieved simultaneously. This study presents a manufacturing-focused evaluation of several fabrication routes for complex pneumatic structures, including heat-shrink forming, silicone casting, powder- and liquid-based additive manufacturing, and fused deposition modeling (FDM). The processes were assessed through process screening, baseline fabrication, failure analysis, and process improvement to distinguish inherent process limitations from correctable manufacturing defects. Heat-shrink forming was limited by geometric conformity, casting by mold accessibility and bonded interfaces, powder-based methods by residual material trapped within enclosed passages, and digital light processing by the material properties and post-processing requirements of the investigated system. FDM provided the most adaptable route because its dominant defects could be progressively reduced through process optimization. The results further showed that airtightness depends not only on nominal wall thickness but also on extrusion-path architecture, while support-free geometry is important when access for internal post-processing is limited. These findings establish a practical design-for-manufacturing approach in which process selection is guided by the compatibility between actuator architecture and manufacturing constraints. The proposed approach provides practical guidance for developing complex, flexible, and airtight soft pneumatic actuators for soft robotic applications
